nikon z8 and powerbanks

run3km

New member
I am looking for some help. i have a nikon z8 and also have 3rd party MB-N12 Power Battery Pack. i use a power bank on event work via the usb c port and works fine with just a normal batter but when i have the 3rd party MB-N12 Power Battery Pack also attached the powerbank does not work via the usb c port. if i plug the power bank into the 3rd party MB-N12 Power Battery Pack it will charge the batteries but not power the camera.

my question is has anyone used the offical MB-N12 Power Battery Pack with the power bank attached in the usb c port . i am wondering if it just the 3rd party one thats causing the issue
 

benhasajeep

New member
I have the MB-N12 but never tried to charge batteries from the camera. But I suspect it's because there is no longer a battery in the camera, they are both in the grip. If the bank does charge the batteries in the grip then I would say all is well. Just have to use that port.

I do know the Nikon grip port will power the camera, and also charge the 2 batteries off camera.
 

Herptiles

New member
I have a 3rd party battery grip (Vello) and notice that the power bank only works with the battery in the camera body using the PD USBc on the camera body, that's unfortunate but at least I figured out what's wrong. Per what I have read it also does not work with the actual Nikon grip either. I can charge the batteries with the grip on using the power bank with the USBc on the grip and it looks like it may actually power the camera with the grip on when using the USBc on the grip, but going to double check this. Though on the camera I see the battery with a plug (in view finder) when i use the power bank on the grips USBc as I did when I had the grip off and used the power bank on the PD USBc on the camera body.
 

TripodNotesNK

New member
From what I've read, the Z8 only accepts USB-C power directly when a battery is in the body, and grips tend to route their own port to charging the grip batteries rather than powering the camera. If you need long event runs from a power bank, one option is to leave a single battery in the body and use the camera's own USB-C port with a PD bank that outputs 9V or higher. Another is to hot-swap grip batteries and charge them off the bank between sessions. It's worth checking the bank's PD profile too, since some cheaper ones negotiate poorly with cameras.
 

Herptiles

New member
Well I am pleased to say that with my 3rd party grip on the Z8 I can power the camera through the usbC on the grip. With the camera off I connect the usbC to the battery grip and the power bank via a usbC-usbc cable. Then I turn the camera on and the power bank is powering the Z8. To check this I charged both batteries in the grip to 100% and powered up with power bank and left camera turned on a couple hours and took a bunch of photos, grip batteries stayed at 100% and the little plug icon next to battery icon in the viewfinder was was evident. Only the power bank went down from full. My set up is the Vello battery grip (from BHphoto), INIU 240W usbC to usbC cable, and the EF Ecoflow laptop power bank 25,000mAh with dual 140W usbC ports and smart display.
 
Top