Manual lens

hrh

Senior Member
My Rokinon 135 (manual lens) and my 50mm 1:1.8 D lens will not function on one of my D500. I have 2

Both cameras have the same firmware C 1:40

There is a differance in the LD 2.018 to 2.017 but I don't think this is the problem.

The settings have been checked and the only difference is when the manual lens are mounted the setting F3 (shutter spd and aperture lock) is shaded. That only occurs in the non working camera.Both of those settings are the same when checked with working lens.

I have cleaned the contacts.

Thank you
 

nikonpup

Senior Member
Screenshot 2026-11-19 193511.png
 

TripodNotesNK

New member
Two things I'd check on the non-working body. For the 50mm D lens, make sure the aperture ring is locked at its minimum (f/22), as a body will refuse to work properly if the ring isn't there. For the Rokinon, set the exposure mode to M or A and register it under Non-CPU lens data in the Setup menu. Also, try a camera reset (the two-button reset) and see if the shaded F3 option is then available.
 

Needa

Senior Member
Challenge Team
You might try backing up the setting for the working camera and installing them in the other. Save/Load setting in the setup menu.
 
Top