Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Nikon DSLR Cameras
D500
Updating the firmware on the Yonquo 685 and 622n-TX
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="GracieAllen" data-source="post: 592269" data-attributes="member: 41283"><p>I'm back up and running...... I tried re-installing the 1.10 firmware. Same result, still the wonky display. I went out and looked for the 1.05 firmware. Didn't find THAT, but I DID find the 1.08 version, so I downloaded that and installed it. Worked fine. TX is back in operation. SO, I reran the 1.10 firmware update AGAIN and it went right back to the bad display. </p><p></p><p>Next, I went out to an alternate location and downloaded the 1.10 firmware again, and installed it. NOPE. Back to the same unusable display. </p><p></p><p>SO, I reinstalled the 1.08 firmware and things are working fine. Apparently, for whatever reason, my 622N-TX does NOT like the 1.10 firmware.</p><p></p><p>Now that I've got that working again, and y'all had good luck getting the firmware updated on the 685, I'll look to see if there's anything in the latest firmware for the 685 that would be important, and if so, give that a try...</p></blockquote><p></p>
[QUOTE="GracieAllen, post: 592269, member: 41283"] I'm back up and running...... I tried re-installing the 1.10 firmware. Same result, still the wonky display. I went out and looked for the 1.05 firmware. Didn't find THAT, but I DID find the 1.08 version, so I downloaded that and installed it. Worked fine. TX is back in operation. SO, I reran the 1.10 firmware update AGAIN and it went right back to the bad display. Next, I went out to an alternate location and downloaded the 1.10 firmware again, and installed it. NOPE. Back to the same unusable display. SO, I reinstalled the 1.08 firmware and things are working fine. Apparently, for whatever reason, my 622N-TX does NOT like the 1.10 firmware. Now that I've got that working again, and y'all had good luck getting the firmware updated on the 685, I'll look to see if there's anything in the latest firmware for the 685 that would be important, and if so, give that a try... [/QUOTE]
Verification
Post reply
Forums
Nikon DSLR Cameras
D500
Updating the firmware on the Yonquo 685 and 622n-TX
Top