Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Learning
Photography Q&A
Super basic portrait lighting setup?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="WayneF" data-source="post: 611182" data-attributes="member: 12496"><p>FWIW, and in One Opinion, the softbox problem for speedlights is much more than just the awkward mounting. The problem is also the fresnel lens on the speedlight, focusing a narrow beam.</p><p></p><p>Your link says the softbox is 32x12.5x25 cm. I assume that means 32x25, and 12 cm deep.</p><p>That is only about 12x10 inches, not very large. And 5 inches deep if the head does not extend very far inside. The head is at most 5 inches from the front panel.</p><p></p><p>So the trig says the 32x25 angle from 12 cm is 106x92 degrees to fill the front fabric.</p><p></p><p>A speedlight coverage at 24mm zoom is about 80x60 degrees FX, or 58x44 degrees DX (from rear of most Nikon flash manuals, SB-910 quoted here). It is designed to cover what a 24mm lens would see.</p><p></p><p>So at most, the speedlght makes a bright spot in the center of the front panel. Kinda like a shoot-through umbrella choked up close. But we can turn it around to be a reflected umbrella, with speedlight at end of a longer shaft, and can fill the entire 45 inch fabric, to be a BIG light, for less money.</p><p></p><p>Light does come out of the small softbox, but whereas studio lights are used bare bulb in softboxes, with greater than 180 degree spread inside there, which the reflective side walls mix all up, and it comes out diffused, like a softbox.</p><p></p><p><strong>Oops!</strong> My bad. It says 32 inches on top line, but says cm on bottom line, which I read. The angles still compute the same regardless, but it is bigger than I thought.</p></blockquote><p></p>
[QUOTE="WayneF, post: 611182, member: 12496"] FWIW, and in One Opinion, the softbox problem for speedlights is much more than just the awkward mounting. The problem is also the fresnel lens on the speedlight, focusing a narrow beam. Your link says the softbox is 32x12.5x25 cm. I assume that means 32x25, and 12 cm deep. That is only about 12x10 inches, not very large. And 5 inches deep if the head does not extend very far inside. The head is at most 5 inches from the front panel. So the trig says the 32x25 angle from 12 cm is 106x92 degrees to fill the front fabric. A speedlight coverage at 24mm zoom is about 80x60 degrees FX, or 58x44 degrees DX (from rear of most Nikon flash manuals, SB-910 quoted here). It is designed to cover what a 24mm lens would see. So at most, the speedlght makes a bright spot in the center of the front panel. Kinda like a shoot-through umbrella choked up close. But we can turn it around to be a reflected umbrella, with speedlight at end of a longer shaft, and can fill the entire 45 inch fabric, to be a BIG light, for less money. Light does come out of the small softbox, but whereas studio lights are used bare bulb in softboxes, with greater than 180 degree spread inside there, which the reflective side walls mix all up, and it comes out diffused, like a softbox. [B]Oops![/B] My bad. It says 32 inches on top line, but says cm on bottom line, which I read. The angles still compute the same regardless, but it is bigger than I thought. [/QUOTE]
Verification
Post reply
Forums
Learning
Photography Q&A
Super basic portrait lighting setup?
Top