Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Learning
Other Photography Equipment
PocketWizard Plus III & FlexTT5
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="rocketman122" data-source="post: 395519" data-attributes="member: 14443"><p>no. not at all. problem is, the promaster light doesnt have a flash foot like the SB700 so the way youd connect the 603II to the promaster is using a sync cable. PC to phono PC.</p><p></p><p>[ATTACH]130740[/ATTACH] </p><p></p><p>you connect one side into the pc connection in the 603 then use the long banana/photo end into the slave, the other slave on the camera, set the channels the same and POP! best way to go about it. </p><p></p><p>I think your flash an optic slave in it (the red light over the sync port) but personally Ive never used an optic slave for the longest time. the radio slaves work and work.</p><p></p><p>oh btw, if later on you want to purchase a speedlight to use on a light stand (known as off camera flash OCF) then you can get a yongnuo 560 IV or III that has a 603II receiver in it so you dont even need to connect one salve to the flash. just put it in slave mode, set channel and youre G2G.</p><p></p><p>cheers.</p></blockquote><p></p>
[QUOTE="rocketman122, post: 395519, member: 14443"] no. not at all. problem is, the promaster light doesnt have a flash foot like the SB700 so the way youd connect the 603II to the promaster is using a sync cable. PC to phono PC. [ATTACH=CONFIG]130740._xfImport[/ATTACH] you connect one side into the pc connection in the 603 then use the long banana/photo end into the slave, the other slave on the camera, set the channels the same and POP! best way to go about it. I think your flash an optic slave in it (the red light over the sync port) but personally Ive never used an optic slave for the longest time. the radio slaves work and work. oh btw, if later on you want to purchase a speedlight to use on a light stand (known as off camera flash OCF) then you can get a yongnuo 560 IV or III that has a 603II receiver in it so you dont even need to connect one salve to the flash. just put it in slave mode, set channel and youre G2G. cheers. [/QUOTE]
Verification
Post reply
Forums
Learning
Other Photography Equipment
PocketWizard Plus III & FlexTT5
Top