Reply to thread

Message: <blockquote data-quote="Eduard" data-source="post: 96438" data-attributes="member: 986">To set your white balance on the D300: 1.) Ensure your card or other neutral object is in the same sort of  light as your subject. 2.) Hold WB and spin the rear dial to get to PRE. 3.) Release WB. 4.) Press and hold WB again for a few seconds. 5.) PRE starts to blink.6.) Release the WB button.7.) Point your D300 at the card and press the shutter.8.) If the display flashes “good” you’re set.9.) If the display flashes “ng” then repeat from step 4.)The D300 stores this as value d-0. You can save five different values  using the menus, numbered d-0 through d-4. d-0 is always the value you  just saved.</blockquote>