Reply to thread

Message: <blockquote data-quote="skene" data-source="post: 220439" data-attributes="member: 13155">64hRelease ModeRelease mode determines how the camera takes photographs: one at a time, in a continuous sequence, with a timed shutter-release delay, or with a remote control. To choose the release mode, press the I button and rotate the main command dial until the desired setting is displayed in the control panel.AThe Memory BufferThe camera is equipped with a memory buffer for temporary storage, allowing shooting to continue while photographs are being saved to the memory card.Up to 100 photographs can be taken in succession; note, however, that frame rate will drop when the buffer is full.While photographs are being recorded to the memory card, the access lamp next to the memory card slot will light.Depending on the number of the images in the buffer, recording may take from a few seconds to a few minutes.Do not remove the memory card or remove or disconnect the power source until the access lamp has gone out.If the camera is switched off while data remain in the buffer, the power will not turn off until all images in the buffer have been recorded.If the battery is exhausted while images remain in the buffer, the shutter release will be disabled and the images transferred to the memory cardAs long as there was some type of action to the memory card... it will take time for the camera to process and the read/write.The camera was probably still working on the memory card at this time. Allow a bit of time before hastily turning off the camera.</blockquote>

Verification