Recent content by ckqualls

  1. ckqualls

    Restore DISP button to default function

    Thank you to everyone. I found it.
  2. ckqualls

    A8 Limit AF Area Mode Not Working

    Thanks.
  3. ckqualls

    A8 Limit AF Area Mode Not Working

    I set A8 (Firmware 2.0) Limiter AF Area Mode Selection to eliminate Pinpoint and all Dynamic options. I programmed one I menu option for AF-area mode/subject detection. When I select that all AF area modes are there, including the ones I eliminated. Looked through the manual, didn't see this...
  4. ckqualls

    Restore DISP button to default function

    D19 is "Half-press to cancel zoom (MF). And I did reset DISP to DISP but got screen attached. From that screen no controls change anything. Firmware 2.0. Thanks for your help
  5. ckqualls

    Restore DISP button to default function

    I re-programmed the DISP button to open My Menu". I would like to restore to its default function. I go to "Custom controls (shooting) and select DISP. button. I thought the "DISP Cycle live view info display" was it and I selected thar. Now when I press DISP I get what is in the attached...
  6. ckqualls

    New to the D200

    I bought mine new in the early 2000's and shot with it for years until I got my D500. Shot vacation in Europe, a lot at the zoo, and some in Montana. Always pleased with the results. Like the controls. I still have mine, haven't shot with it in years. Enjoy!
  7. ckqualls

    Bison Enforcing Traffic Regulations

    Caught this in Montana is 2007.
  8. ckqualls

    Rhino 25,000 iso

    Great photographs! I shoot a Z6III and when I shoot for my church it's dark and ISO goes to 64,000. Church shoots Sony. They are amazed there isn't any appreciable grain. I respond "Hey, it's a Nikon".
  9. ckqualls

    2 blue jays in flight together! !Nikon Z6III with Nikkor 200-500 f5.6 at 200mm.

    Took about 350 exposures to catch this. It isn't often 2 blue jays go to the feeder at the same time.
  10. ckqualls

    Auto ISO Blinking

    Thank You
  11. ckqualls

    Solved: Z6III Dirty Sensor

    Thanks everyone. Cleaned sensor, problem solved.
  12. ckqualls

    Auto ISO Blinking

    Auto ISO blinking in viewfinder. ISO Sensitivity Settings: Maximum Sensitivity Hi1 Maximum Sensitivity with Flash 64000 Minimum Shutter Speed 1/60th second My photo's exposure is OK even with it blinking. Camera in manual mode. Firmware 2.0 Do these look right? Any other settings I should...
  13. ckqualls

    Battery Warning

    I'm getting this warning on a Z6III I've had a year. Just started today. Happened twice. The batteries (2 in a MB-N14) are Nikon EN-EL15C, not a third party. If I remove the batteries and re-insert, camera works fine for a while, then I get the error message again. I tried to take a photo...
  14. ckqualls

    Birds in My Back Yard

    Took these over the past 2 days. Nikon Z6III with Nikkor 200-500 f5.6 at 500mm.
  15. ckqualls

    Setting to Keep Button Press Active

    Works great! Thank You!
Top