BackdoorArts
Senior Member
Got my D600 back from Nikon this evening. Have not shot anything with it, not have I inspected the inside yet - I want to wait until I have time tomorrow and do it in as clean an environment as possible. But I did want to share with you the work done. No explanation was given as to anything found during the inspection, I simply sent it in explaining about the repeated dust issues.
In the Material Description field of the Repair Invoice it states the following:
I have no idea if the adjusting of the Auto Focus is standard procedure on these types of operations, and I'm assuming the side rubber gets replaced when the camera gets disassembled. Would be curious if anyone else getting this work done had anything different?
Looking forward to shooting with it again tomorrow.
In the Material Description field of the Repair Invoice it states the following:
Service Repair Bank B1
Write Up
Repair SC201759
*
RPL SHUTTER MECHANISM
RPL REWIND SIDE RUBBER
ADJ AUTO FOCUS OPERATION
CLN LOW PASS FILTER
GENERAL CHECK & CLEAN
GENERAL CHECK & CLEAN
GENERAL CHECK & CLEAN
GENERAL CHECK & CLEAN
Write Up
Repair SC201759
*
RPL SHUTTER MECHANISM
RPL REWIND SIDE RUBBER
ADJ AUTO FOCUS OPERATION
CLN LOW PASS FILTER
GENERAL CHECK & CLEAN
GENERAL CHECK & CLEAN
GENERAL CHECK & CLEAN
GENERAL CHECK & CLEAN
I have no idea if the adjusting of the Auto Focus is standard procedure on these types of operations, and I'm assuming the side rubber gets replaced when the camera gets disassembled. Would be curious if anyone else getting this work done had anything different?
Looking forward to shooting with it again tomorrow.