Forums
New posts
Search forums
What's new
New posts
New media
New media comments
New profile posts
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
New profile posts
Search profile posts
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Nikon DSLR Cameras
D5100
Need help with my SB-910 Speedlight and my Nikon D5100.. .
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Message
<blockquote data-quote="Fred Kingston" data-source="post: 109523" data-attributes="member: 10742"><p>Look in your manual... using the menus, you want to set the camera in Commander mode... and you want to set the 910 to remote... The camera's IR light will send a flash that triggers the IR light sensor on the 910...the 910s IR sensor (the round red thingy on the right side of the 910) will need to be lined up so it's line-of-sight from the camera... You can set both a Channel and a GRoup on the camera, and it needs to be set for the same on the 910... When you fire the camera, the 910 should fire also... I believe you're limited to something like 30' between the camera and the flash... You don't need any additional equipment unless you can't do line-of-sight between the devices... If the distance or position prevents the above from working... you'll need to buy a radio control system to trigger the flash remotely... </p><p></p><p>Setup a test with the devices 5' apart and aimed at each other until you get all the parts working...then position your light where you want it...</p></blockquote><p></p>
[QUOTE="Fred Kingston, post: 109523, member: 10742"] Look in your manual... using the menus, you want to set the camera in Commander mode... and you want to set the 910 to remote... The camera's IR light will send a flash that triggers the IR light sensor on the 910...the 910s IR sensor (the round red thingy on the right side of the 910) will need to be lined up so it's line-of-sight from the camera... You can set both a Channel and a GRoup on the camera, and it needs to be set for the same on the 910... When you fire the camera, the 910 should fire also... I believe you're limited to something like 30' between the camera and the flash... You don't need any additional equipment unless you can't do line-of-sight between the devices... If the distance or position prevents the above from working... you'll need to buy a radio control system to trigger the flash remotely... Setup a test with the devices 5' apart and aimed at each other until you get all the parts working...then position your light where you want it... [/QUOTE]
Verification
Post reply
Forums
Nikon DSLR Cameras
D5100
Need help with my SB-910 Speedlight and my Nikon D5100.. .
Top