Focus point after recomposing on View NX2

amonamarth

Senior Member
Hello:
I wanted to check focus point on View NX2, but found out I couldn't :(
I took this by focusing on the petals, then recomposed before pressing shutter release all the way down.
It was set to single-point focus using the focusing point in the middle of the frame.

Is there another way of taking this picture the same way (I mean using one focus point and recomposing) and still having the focus point placed properly on the frame?
Any other ways in which YOU take this picture to keep the focus point information on View NX2 accurate?
Thanks in advance.

focus_point.png
 

westmill

Banned
I think it can only show the focus point used on the camera not where its focussed on the picture.
You would have been better choosing a lower focus point than using the centre and recomposing
since the mere act of recomposing at such a short distance would alter where you actualy focussed.
Nice piccy though !
 

amonamarth

Senior Member
yeah, I'm just used to focus, recompose, shutter release ... I hate navigating with button to pick a focus point :(
Thanks, I cropped it and I think it looks better.
 
Top